Page 1 of 1
Auto pilot
Posted: Mon Dec 02, 2019 10:39 am
by Larry cessna
Anyone Know how many C c's of ram on a 1998 all been TE. I am looking to buy an autopilot and M not near my boat at the time
Re: Auto pilot
Posted: Mon Dec 28, 2020 2:14 pm
by DougA
My '96 28TE is 118 cc or 7.2 cubic inches. It's a Seastar BA125-7ATM 118cc, HC5312
The ram leaks so I'm getting a new one this week, as part of Raymarine autopilot install.
Re: Auto pilot
Posted: Mon Dec 28, 2020 2:24 pm
by DougA
PXL_20201214_010227246.jpg
Steering rudder sensor and steering ram
Re: Auto pilot
Posted: Wed Dec 30, 2020 10:24 pm
by carolmarie
My 2001, 28TE has the same part ramnumber as Doug’s but doesn’t leak
. (Approx. 1100 hours.)
Don.
Re: Auto pilot
Posted: Thu Dec 31, 2020 3:15 pm
by DougA
Hi Don. Few years ago with my C-Dory, I had leak from the outboard engine ram. I was told by Seastar tech that ram leak can result from tiny sharp spot on underside of rod. Sharp spot created from corrosion and non-use in salty environment. Sharp spot makes tiny cut on gland. I was able to fix leak with a rebuild kit and a small file, used carefully.
This time I chose not to try rebuild because with this ram you need to purchase a special tool in addition to the rebuild kit. Also I got a good price on the new ram.
So when boat is stored, periodically rinse ram with fresh water and move steering wheel position. Doug
Re: Auto pilot
Posted: Wed Mar 03, 2021 7:34 am
by Wfmdfm
If you use crocus cloth to smooth the ram. It should take off small high spots but does not scuff up the shaft.
. (Approx. 1100 hours.)