28TE engine mounts

Post by **Russell** » Sat Dec 23, 2017 5:50 pm

I had to pull the engine on my 1997 Albin 28 and the mechanic replaced all the motor mounts and the difference at low RPMs was amazing. It used to rattle the windows and vibrate the floor and after the change it was smoother and quieter. I just bring this up in case there is any doubt about the condition of the rubber in the old mounts. It might be worth it to replace all 4.

Post by **Nancy** » Sat Dec 23, 2017 9:44 pm

Russell wrote: ↑Sat Dec 23, 2017 5:50 pm I had to pull the engine on my 1997 Albin 28 and the mechanic replaced all the motor mounts and the difference at low RPMs was amazing. It used to rattle the windows and vibrate the floor and after the change it was smoother and quieter. I just bring this up in case there is any doubt about the condition of the rubber in the old mounts. It might be worth it to replace all 4.

Thanks, Russ! Ours hasn't bad, but it would be nice to get some improvement.

Albin Owners Group

Albin Owners Group

28TE engine mounts

Re: 28TE engine mounts

Re: 28TE engine mounts