Windlass wiring

Post Reply
Larry cessna
Mate
Mate
Posts: 10
Joined: Thu Dec 06, 2018 4:12 pm
Home Port: delaware

Wed Aug 14, 2019 12:37 pm

I have a 1998 28 te and am looking to install a windless. Anyone know where the pre wires go. I see them in the rope locker but not behind the helm or at the battery? Also what windless would you recommend. I will be using the boat in the Chesapeake Bay.

Yearwood
Supporting Member
Supporting Member
Posts: 202
Joined: Mon Mar 19, 2007 7:20 am

Wed Aug 14, 2019 9:01 pm

If I recall ours terminated near the batteries. It was tough drilling though for the chair to the locker.

Last year we replaced our windlass with the Lewmar Profish 700 selected because it had the same footprint as our Horizon 600 installed perhaps 16 years ago. The Horizon was fine but took too much abuse when holding a capsized log canoe, sails, spars, crew, etc. in a 20 knot wind. A shaft bent and it kept failing afterward.
Don

User avatar
catalina_mike
Gold Member
Gold Member
Posts: 580
Joined: Mon Mar 09, 2015 11:20 am
Home Port: Dana Point

Thu Aug 15, 2019 10:16 am

My wire was attached to the battery switch when I purchased. It runs along the Starboard side and was not factory, 1999, it appears.
Albin 1999 28TE
SSI Instructor 13937
SDI / TDI Instructor 18172
USCG 100 Ton near coastal

User avatar
Sisu22
Supporting Member
Supporting Member
Posts: 174
Joined: Sun May 07, 2017 6:50 pm
Home Port: Ventura, CA

Fri Aug 30, 2019 10:19 am

My wiring runs up through the galley. But it looks aftermarket in that it is not true 'marine' cable. On my list to replace one of these years, or I may install a dedicated battery forward for the thruster & windlass.
1994 TE 28' w/ Cummins 250

Post Reply

Return to “Tournament Express 26-35”

  • Information
  • Who is online

    Users browsing this forum: No registered users and 2 guests